PRODUCTS
CONTACT US
Reverse osmosis technology is a membrane separation technology, which is used together with the pre-treatment system. The pressure of the high-pressure pump and the interception of the reverse osmosis membrane can effectively remove solid dissolved matter, organic matter, colloids, microorganisms and bacteria. It has a wide application range, high degree of initiative, small footprint, low energy consumption and good effluent quality. For the knowledge about the installation and operation of reverse osmosis pure water equipment, the reverse osmosis pure water equipment manufacturers summarize the following for you:
1. Place the reverse osmosis pure water host and preprocessor close to the water source and power source.
2. Install filter materials such as quartz sand, activated carbon and softened resin.
3. Connect the waterway: the original water pump inlet is connected with the water source, the pre-filter outlet is connected with the main engine inlet, and the pre-processor and the main unit drain are connected to the sewer by pipeline.
4. Circuit: Firstly, ground the grounding wire reliably, and connect the power cord that is randomly connected to the electric control box of the room.
5. Pass the water source and power supply, follow the steps of “Pre-treatment Operation Instructions”, and the pre-treatment debugging operation is completed.
6. Use this machine, the original water pump switch, dial in the automatic position, and unscrew the stop switch. Turn on the water source and power supply. When the multi-stage pump port pressure reaches the set value of the pressure controller, the multi-stage pump starts working. After the multi-stage pump is started, adjust the system pressure to 1.0-1.2Mpa. Pre-start the RO membrane system for manual flushing for 30 minutes.
Reverse osmosis pure water equipment is widely used in various fields. In order to better realize the function of reverse osmosis pure water equipment, it is very important to install it correctly.